Punching plate foundation pit fence Standardized foundation pit edge fence Construction site enclosure
Height: 1.2m, 1.5m
Length: 2 meters
Border: 2030, 3030, thickness: 0.8mm-1.5mm
Mesh: 4040, 5050
The mesh surface can be made of steel mesh or wire mesh, and the steel plate is punched.
Column: 5050, 6060, thickness: 0.8mm-1.5mm
The column can be installed in a pre-embedded or chassis-mounted manner, with flanges (4mm×15cm×15cm steel plates) at the bottom. Each flange is provided with four bolt holes, which are fixed to the ground with Φ14 expansion bolts.
Punching steel plate foundation pit Hengshui stereotyped foundation pit fence
Surface treatment: electrostatic spraying, painting, spray painting
Surface color: yellow and black, white and red. The mesh design is yellow and black, and the column is white and red.
Characteristics of the fence for foundation pit at the construction site:
The edge protection fence for the foundation pit on the construction site consists of protective mesh and columns. The protective mesh for the foundation pit enclosure fence is made of welded 2cm×3cm square tubes, with a single piece size of 1.1 meters×1.7 meters. Both ends are equipped with Φ10 bolts for cross-ears to connect and fix with the columns, and the distance between the cross-ears and the upper and lower edges is 15cm.
After installation, the upper edge of the guardrail should be flush with the column, and the lower edge should be 20cm above the ground. The distance between the two columns should be 2 meters.
Construction shall be carried out according to the drawing, with correct dimensions and firm welding points.
Punching plate foundation pit fence Standardized foundation pit edge fence Construction site enclosure
